![]() ![]() Where the network cable from the camera plugs in to the powerline adapter, you should see a steady orange light, and a blinking green light. The LED switch on the side of the powerline adapter will turn ALL the LEDs either on or off. But then the Alert software has the ability to put a password on the powerline network, so there's potentially that complication. I've never seen the MAC address of the powerline adapter in the router listings, only the device connected to the adapter. I would guess that by pressing the reset on the bottom of the camera it would clear any settings from the camera in regards to previous network settings, but then there's the relationship between what the camera is doing and the powerline adapter. We will diagnose the connection issue first. I actually had a mix of Wilife and Alert cameras running in Blue Iris 3/4. I may be able to help, I started with a Logitech Wilife system, then upgraded to an Alert system, before going down the rabbit hole of IP cameras and Blue Iris. Launched the logitech alert application (New camera not recognized, Old ones recognized)ĭoes anyone have an idea on how to make it work?.Checked my router for any mac filtring but it's deactivated so the issue does not come from my network apparently.To reset by pressing the reset button with a paper clip for 10 second, the green network LED blink once and that's all.to echange the non working new camera with a working one by connecting the new one at the same cable but same behavior.Bottom Status LED OFF (It's possible my friend deactivated it but he doesn't remember).The 2 new camera have the same behavior : It seems they are not recognized by my network. ![]() When I connect them to my existing logitech alert camera network the same way as I do with 3 existing 700e, then the 2 new one are not visible under my router page. The HomePlug router for connecting to your home LAN network (left) and the power adapter (right) for the Logitech Alert cameras.A friend gave me 2 logitech Alert 700e camera he bough years ago and almost never used. The micro-SD card slot with 2GB storage card is located on the right. The cameras are powered by Power-over-Ethernet (PoE). Video from the cameras can also be automatically copied to a local PC for archiving. Overall, the software is intuitive, easy to use and good looking. Various configuration settings can be tweaked via the Alert Commander app, including motion detection parameters and sensitivity. Next, you plug in the HomePlug router to a power source and connect it to a free LAN port on your network router. When you launch the Alert Commander application on your PC, a Add/Find wizard should detect both camera units, and you should see live video feeds on the display pane. To setup the system, you must first install the Logitech Alert Commander software and plug in the two cameras. The Master System also came with an additional HomePlug router. Both units came with suction cups for window mounting and desktop docks. Both packages contained the same camera, a power adapter, a Quick Start guide, installation CD and a network cable. For this review, Logitech sent me an Alert 750n Indoor Master System with Night Vision and an Alert 700n Indoor Add-On Camera with Night Vision. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |